2008-11 FORD FOCUS MK2 US
shift boot installation guide

1. Remove shift knob by turning counter clockwise.

2. To remove the shift boot, press the 2 ÒAÓ part in the picture and lift the rear part first (B).

3. For the top part (C), use a flat screwdriver to remove the plastic ring, only if you want to reuse the OEM shift knob. Remove the boot from the plastic trim. ItÕs easier to start from one corner. Once the first one is done, the rest should be easy to do.

4. To remove the E-Brake boot, just press the 2 ÒDÓ part in the picture, lift the front part (E) first and when the plastic trim is remove just slide the boot over the E-Brake handle. Remove the boot from the plastic trim.

5. Glue the new ebrake boot in place starting by the front, and after a bit a both side until you reach the back part. You might need to trim a bit to have everything to fit in place.

6. Glue the new shift boot on the plastic trim. Start by doing the four corners after this is done, glue the four sides. If you reuse the OEM shift knob, Glue the top part and put the plastic ring in place.

7. Reinstall everything in the reverse order of removal and you're all set!

CONGRATULATIONS - YOU HAVE SUCCESSFULLY INSTALLED YOUR NEW LEATHER BOOTS!

Useful tip

You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.

Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk.