1990-00 MITSUBISHI GTO/3000GT
automatic shift boot installation guide

1. Remove the rectangular plastic trim around the perimeter of the gear selector, this will be the anchor for the leather boot. Simply slide a small screwdriver under and push up. It pops out quite easily.

2. Place the Plastic ring inside the shift boot, be sure to mark where the 4 plastic tabs are, as you will need to measure 1cm (3/8") down and cut a slit for the tabs to fit into. BE VERY CAREFUL! IF YOU MEASURE MORE THAN 1CM THERE WON'T BE ENOUGH SLACK FOR THE SHIFT TO MOVE FULLY THROUGH ALL GEARS!!!

3. With plastic ring attached (as shown above) pull boot inside out and slide top first over shift stalk. Secure with a zip tie.

4. Push top down over zip tie and secure plastic trim. Be sure the leather is tucked in all around, or else you will have ends sticking out. To secure the trim, you will need to give it a good whack. Dont be afraid about break anyhting, The dash is foam and plastic wont bend.

5. Pull the old e-brake boot inside-out as is shown in the picture.

6. Remove the plastic zip-tie to separate the boot from the e-brake. We recommend a razor blade for this.

7. Position your new genuine leather e-brake boot into the same position and use a zip-tie or rubber band to affix the boot to the e-brake. We again recommend using a rubber band.

8. Pull the e-brake boot back down.

ENJOY YOUR NEW LEATHER BOOTS!